Safe cleaning - 6 steps of car detailing

A well-kept car is a clean car - that's how you can say it, of course. The condition and appearance of the car will tell a lot about the owner. Here again appears a statement how they see you as they write you. Every new car will look great, but remember that such a beautiful star will fade over time. How long the paint will look good will depend solely on us.

Today's cars unfortunately have such paints, which are most often very delicate and soft. Lack of proper care will cause that matting will appear quickly and a large number of scratches. Many years of experience of car care specialists will make us have a few tips on how to safely wash such a car, which will have to be remembered.

Step one - Thorough flushing of the body of our vehicle

At this stage we use a high-pressure cleaner and rinse very thoroughly the volatile dirt from the paint as well as from the wheel arches or rims. The idea is to remove as much dirt as possible in a non-contact manner.

Second step - Wheel cleaning

In the second step you will be able to move on to wheel cleaning and here you will be able to remove the dirt using special preparations that serve this purpose, because thanks to them you will be able to dissolve the dirt effectively and it will simply become easier to remove it.

Avoid using cheap market products. effectiveness leaves much to be desired, sometimes they can do more harm than good. Remember to respond to the time set by the manufacturer when it comes to contact with dirt.

Third step - Pre-washing, i.e. active foam

If the paint is thoroughly rinsed off, it will be possible to dissolve dirt on it, which the water itself has not been able to remove. Currently, the choice of foamers and active foams is quite large, so something to your expectations will surely be selected. After applying the foam, it will wait for a flush that lasts up to 10 minutes. The foam will dissolve the sediments.

Step four - Basic cleaning

When the rest of the foam has been flushed, the basic cleaning can be carried out. Here, of course, the best method for two buckets, which will be the most practical and will give the best effect, because by rinsing a cloth or glove in clean water there is no fear that we will scratch the paint.

Fifth step - Drying

Nothing will be easy in detailing and there will be a lot of interesting options here as well. You can use absorbent towels, soft microfibre towels or you can use a compressor for dehumidification.

Sixth step - Quick detailer

It is necessary to apply a preparation that will allow us to overcome any leaks that may result from the presence of hard water. This Quickdetailer gives depth to the paint and fills in the protective coatings applied earlier, so they will last longer.